Netgear MA401Forum: Networking Topic: Netgear MA401 started by: GbMax78 Posted by GbMax78 on Sep. 01 2008,22:21
I have a pcmcia Netgear MA401, i have read < http://damnsmalllinux.org/wiki...._Box.22 > and I have see my card on Cards That Work "Out of the Box".Now i haven't understand what is the right way to configure the card... On a Debian I have an old d-link (DWL-G650+) and I use ndiswrapper with Knetwork manager... GbMax78 Posted by roberts on Sep. 02 2008,03:46
The ma401 has had many chipsets over various versions.I would check to see if it recognized out of the box by doing an iwconfig command. If you see no wireless extenions then you will need to see which chipset you have. Otherwise you can use the iwconfig gui to configure the card. Note that WEP key is entered as colon separated pairs. Posted by GbMax78 on Sep. 06 2008,07:14
root@box:~# iwconfiglo � � � �no wireless extensions. eth0 � � �no wireless extensions. eth1 � � �IEEE 802.11-DS �ESSID:"" �Nickname:"Prism �I" � � � � �Mode:Managed �Access Point: 44:44:44:44:44:44 �Bit Rate:2Mb/s � � � � � �Tx-Power=15 dBm � Sensitivity:1/3 � � � � � �Retry min limit:8 � RTS thr:off � Fragment thr:off � � � � �Encryption key:off � � � � �Power Management:off � � � � �Link Quality:0/92 �Signal level:-68 dBm �Noise level:-122 dBm � � � � �Rx invalid nwid:0 �Rx invalid crypt:0 �Rx invalid frag:0 � � � � �Tx excessive retries:0 �Invalid misc:0 � Missed beacon:0 The chipset is Prism ? On this pcmcia i can use only WEP ? It is possible load WPA ? You know a 16 bit pcmcia wi-fi card for WPA use ? GbMax78 Posted by roberts on Sep. 07 2008,21:29
Looks like the card is recognized, just need to configure it using eth1 as the device. You can try the iwconfig gui. I doubt wpa is supported on this card.
|